The Material Slips Away From The Pinch Rollers During Cutting; Is The Loading Lever Lowered; Is The Material Loaded In Parallel With The Guide Lines; Is The Material Making Contact With Some Obstacle During Cutting - Roland VersaSTUDIO GS2-24 User Manual

The Material Slips Away from the Pinch Rollers
during Cutting

Is the loading lever lowered?

If it is, the material is not secured in place. Check that the pinch rollers are within the edges of the mate-
rial, and raise the loading lever.

Is the material loaded in parallel with the guide lines?

Use material with left and right edges that are parallel, and align the left edge of the material so that it
lies parallel to the guide lines.
RELATED LINKS
・
P. 26Loading Position of Material

Is the material making contact with some obstacle during cutting?

Make sure that the left and right edges of the material do not make contact with the inner surfaces of the
machine during cutting. Such contact not only damages the material, but also hinders normal material
feed and causes the material to slip out of position.
Has cutting been performed without checking the material feed? (roll materi-
al)
If you start cutting without checking the material feed, correct cutting results may not be obtained. In the
worst case, it may cause an error, malfunction, or damage the material.
RELATED LINKS
・
P. 39Check Material Feeding

Are the pinch rollers used to secure both edges of the material?

If the pinch rollers are not placed within the range of the grit rollers, the material is not secured, which
prevents it from being fed properly.
Reload the material.
RELATED LINKS
・
P. 26Loading Position of Material
289
Cutting Problems