Cropmark Error""Length Ng; Cropmark Error""Width Ng; Out Of Cut Range; Sheet Unloaded - Roland VersaSTUDIO GS2-24 User Manual

"CROPMARK ERROR""LENGTH NG"

Crop mark 3 is deviated by 20 mm (0.79 in.) or more in the material feed direction.
: Crop marks 3
Press any key to clear the error message. Reload the material or change the position of crop mark 3.

"CROPMARK ERROR""WIDTH NG"

Crop mark 2 is deviated by 20 mm (0.79 in.) or more in the cutting carriage direction.
: Crop mark 2
Press any key to clear the error message. Reload the material or change the position of the crop mark 2

"OUT OF CUT RANGE"

This message indicates that the crop marks or the origin are set outside the material.
Press any key to clear the error message. Check that the crop mark positions or the origin are not set out-
side the material, and redo the settings.

"SHEET UNLOADED"

An attempt was made to make the machine ready without loading material. The material was removed
when the machine was ready to perform cutting. The material slipped out during cutting.
Press any key to cancel setup and clear the error message. Load the material correctly, and then make it
ready for cutting (setup condition).
RELATED LINKS
・
P. 26Loading Position of Material
Error Messages
Messages on the Operation Panel
323