Table of Contents
Advertisement
Error Messages
This section describes the error messages that may appear on the machine's display and how to take action
to remedy the problem. If the action described here does not correct the problem or if an error message
not described here appears, contact your authorized Roland DG Corporation dealer.
"WRONG COMMAND"
Data that the machine is not able to interpret was sent.
Press any key to clear the error message. Review the data sent from the computer, and then send the cor-
rect data.
"WRONG NO.S"
The number of parameters differs from the permissible number.
Press any key to clear the error message. Review the data sent from the computer, and then send the cor-
rect data.
"OUT OF RANGE"
The value of the specified parameter was outside the permissible range.
Press any key to clear the error message. Review the data sent from the computer, and then send the cor-
rect data.
"ORIGIN ERROR"
The machine is exposed to direct sunlight or strong indoor lighting and was not able to detect the ori-
gin immediately after the power was switched on.
Turn off the power, and move the machine to a location where it is not exposed to direct sunlight or in-
tense light. Then, turn on the power.
"CROPMARK ERROR"
The shape or color of the crop marks, or the color or glossiness of the material is not suitable for the
machine. The issue may also be due to mechanical failure.
The machine was not able to read the crop marks. Check the shape and color of the crop marks, and the
color and glossiness of the material.
If the same error occurs even after you have reviewed the shape and color of the crop marks, and the col-
or and glossiness of the material, contact your authorized Roland DG Corporation dealer.
"CROPMARK ERROR""ANGLE TOO BIG"
Crop mark 2 or 3 is slanted by 5 degrees or more.
321
Messages on the Operation Panel
Advertisement
Table of Contents
