Preparations for Cutting Output
Step 3: Perform Test Cutting
Adjust the cutting conditions according to the types of material and the cleanness of the cut. To obtain
high-quality cutting results, carry out a cutting test to check the cutting quality for the material before
you perform the actual cutting.
Procedure
1.
Check that the PEN FORCE slider is at the center position (at "0" on the scale).
▲
▲
2.
Press [▲][▼][◀][▶] to move the cutting carriage.
Move the cutting carriage so that the blade tip points the start position of the cutting.
MEMO
To move the material or the cutting carriage fast, press [ENTER] together with one of [▲][▼][◀][▶] while
one of the following screens is shown.
20cm/s
250gf 0.250mm
W:***mm
L:***mm
3.
Hold down [TEST] for one second or longer.
Cutting of the test pattern will start at the blade position where[TEST] is pressed.
4.
Once the cutting is completed, press [▼] to feed the material forward.
44
Basic Operation
-2
-1
0
+1
+2
A