Adjusting the Cutting Position
If the printing position and the cutting position are offset as shown in the following figure, you can correct
the issue by adjusting either the printing position or the cutting position. This example shows the proce-
dure for adjusting the cutting position.
: Intended cutting line
: Actual cutting line
Procedure
1.
Check that the material has been loaded.
2.
Check the correction values based on the cutting status.
"CROP-L" indicates the feed direction of the material, and "CROP-W" indicates the moving direction
of the cutting carriage.
Example: To move the cutting line 0.5 mm (0.02 in.) to the right ( ) and 0.7 mm (0.03 in.) up ( )
+
-
-
• CROP-W: Set to +0.500
• CROP-L: Set to +0.700
3.
Press [MENU] several times to display the following screen.
UNSETUP
4.
Press [▼] to display the following screen.
+
Preventing and Correcting Misaligned Cutting
Optimizing Cutting Quality
215