Condition - Roland VersaSTUDIO GS2-24 User Manual

・
P. 194Optimizing Quality and Efficiency

"CONDITION"

Here, cutting conditions including blade force and cutting speed are set and confirmed. The settings affect
the cutting quality. Change the cutting conditions according to the material you are using.
• "FORCE"
FORCE 50gf
The blade force can be set. If the design peels off or if the carrier paper is also cut together with
the material, change the setting of "FORCE".
P. 198Setting the Blade Force
• "SPEED"
SPEED 40cm/s
The cutting speed can be set. If the cutting line is distorted or if partial uncut areas remain,
change the setting of "SPEED".
P. 200Setting the Cutting Speed
• "OFFSET"
OFFSET 0.250mm
The blade tip offset can be set. If the beginning of a cut deviates from the intended location or if
the corners of a shape are not clean, change the setting of "OFFSET".
P. 201Setting the Blade Tip Offset Amount
• "UPSPEED"
UPSPEED 40cm/
The speed for lifting the blade off the material and moving it to the next cutting position during
cutting operation can be set. When cutting material that is thinner or thicker than the standard
material, change the setting of "UPSPEED" to prevent problems such as material being lifted up.
P. 206Setting the Speed of the Blade During Cutting
• "ROTATE"
ROTATE 0deg A
Cutting coordinates can be rotated, and the cutting direction of the material can be set.
P. 202Set the Orientation of Cutting Coordinates
• "QUALITY"
QUALITY NORMAL
The cutting quality can be set. In cases such as using thick material, change the setting of "QUALI-
TY".
• "EXTEND"
EXTEND 0.0mm
Checking the Display Menu
Basic Operation
21