Crop Marks Are Not Detected
When the machine cannot read crop marks, it displays the following error message and pauses operation.
• "SET TO <TOOL MODE>"
• "LENGTH NG"
• "WIDTH NG"
• "ANGLE TOO BIG"
If this happens, press any key on the operation panel. Remove the material, check the following items,
and then reload the material.
Is the material loaded correctly?
Make sure that the material is loaded and set up correctly.
RELATED LINKS
・
P. 26Setting Up Material
Are you using material that is not white or is glossy?
Crop marks cannot be detected if decorations or colors are on the material. Crop marks also cannot be
detected on glossy material even if it is white.
Prepare a white, matte (minimally glossy) material and redo the process from the printing step.
RELATED LINKS
・
P. 15Conditions for Usable Materials
Are you using a transparent material?
Crop marks cannot be detected on transparent material. Change the material you are using.
RELATED LINKS
・
P. 15Conditions for Usable Materials
Does the material have creases or wrinkles?
Crop marks may not be read if the material has creases or wrinkles.
Stretch the creases or wrinkles out and load the material again. If the crop marks still fail to be read, pre-
pare new material without creases or wrinkles and redo the operation from printing the data.
Are the crop marks blurred or are they in a color other than black?
Set the color of crop marks to black, specify 100% printing density on your printer, and print the data
again.
RELATED LINKS
・
P. 16Crop Marks
286
Cutting Problems