Step 4: Cutting (Manual Mode) - Roland VersaSTUDIO GS2-24 User Manual

Step 4: Cutting (Manual Mode)

WARNING
Never touch the cutting carriage while output is in progress.
The cutting carriage moves at high speed. Coming into contact with the moving carriage may cause injury.
Procedure
1.
Press [◀], then [▼] to display the screen shown below.
For 3 tool marks, select "3-POINT START".
MANUAL
4-POINT START
2.
Press [ENTER].
The screen shown below appears.
REPLACE TO TOOL
(QUIT MENU)
3.
Remove the blade holder and install the alignment tool.
The alignment tool can be installed in the same manner as the blade holder.
4.
Press [ENTER].
The screen shown below appears.
MARK1 SET
(RETURN MENU)
5.
Press [▲][▼][◀][▶], and align the tip of the alignment tool with tool mark 1.
Hold down the alignment tool gently from above with your finger and check that the tip of the
alignment tool overlaps the tool mark.
Print & Cut in Manual Mode
Other Cutting
191