Table of Contents
Advertisement
Error Messages
"SET TO <SENSOR MODE>"
Crop mark data was sent when the machine was in Manual Mode.
Press any key to clear the error message. Change the machine's settings to Sensor Mode, and then resend
the data.
RELATED LINKS
・
P. 72Configure the Setting to Perform Automatic Aligning
"SET TO <TOOL MODE>"
Crop marks could not be read in Sensor Mode.
Press any key to clear the error message. Change the machine's settings to Tool Mode, and then resend the
data. When doing so, use four crop marks. When the machine is in Tool Mode, it is not possible to cut using
3 crop marks.
If you want to use three crop marks, leave the machine in Sensor mode and change the shape and color of
the crop marks or the color and glossiness of the material.
RELATED LINKS
・
P. 16Crop Marks/Tool Marks
・
P. 286Crop Marks Are Not Detected
"DATA OVERFLOW"
The amount of data stored in the machine is too large and "REPLOT" cannot be executed.
Procedure
1.
Delete the data stored in the machine.
2.
Decrease the size of the data sent from the computer and resend it.
3.
Carry out "REPLOT".
RELATED LINKS
・
P. 222Cutting the Same Data Repetitively
"BAD POSITION"
Pinch rollers are at positions where the material cannot be pinched.
Press any key to cancel setup and clear the error message. Move the pinch rollers to the correct positions
and reload the material.
MEMO
If the message appears even if the pinch rollers are moved to the correct positions, the machine may be exposed to
direct sunlight or intense indoor lighting. Turn off the power, and then move the machine to a location where it is not
exposed to direct sunlight or intense lighting.
After moving the machine, turn on the power.
324
Messages on the Operation Panel
Advertisement
Table of Contents
