Preventing Misaligned Cutting - Roland VersaSTUDIO GS2-24 User Manual

Preventing Misaligned Cutting

Material is automatically fed before and during cutting in order to avoid misalignment of cutting positions.
If this is set as "ON", the material is automatically fed forward for 1 m (3.28 ft.) whenever the computer
sends out cut data (depending on the data, the material may be fed out 1 m (3.28 ft.) or more), then the
cutting starts.
MEMO
If material has already been fed out using the "AREA" function, the material will not be fed out automatically for the
amount that has already been fed out, even if "PRE-FEED" is set to "ON".
Procedure
1.
Press [MENU] several times to display the following screen.
CONDITION
MEMO
When the material is loaded, press [MENU] several times to display the following screen.
UNSETUP
2.
Press [▼] several times to display the following screen.
OTHERS
3.
Press [▶].
4.
Press [▲][▼] to display the following screen.
PRE-FEED OFF
5.
Press [▶].
6.
Press [▲] or [▼] to select "ON" or "OFF".
PRE-FEED OFF
*OFF
7.
Press [ENTER] to select the setting.
8.
When "ON" is selected, set the material feeding speed.
(1)
Press [▶] twice to display the screen shown below.
SPEED 40cm/s
Preventing and Correcting Misaligned Cutting
Optimizing Cutting Quality
213