Adjusting the Cut Setting
Extending the Cutting Area
Extending the cutting area allows for maximum material usage.
MEMO
Depending on the design to be cut, the pinch rollers may pass over the top of the cutting line.
Procedure
1.
Press [MENU] several times to display the following screen.
CONDITION
MEMO
When the material is loaded, follow the following procedure to display the screen.
1. Press [MENU] several times to display the following screen.
UNSETUP
2. Press [▼].
2.
Press [▶].
3.
Press [▲][▼] to display the following screen.
EXTEND 0.0mm
4.
Press [▶].
5.
Press [▲] or [▼] to select a value.
EXTEND 0.0mm
10.0mm
IMPORTANT
• The set value is applied to both ends of the cutting area.
• If "EXTEND" is set after loading material, the "W" value displayed on the operation panel will differ from the
actual cut width.
204
Optimizing Cutting Quality