Table of Contents
Advertisement
3-5 Cutting Test - Setting Cutting Speed, Blade Force, and Blade Compensation
For optimum performance, it is necessary to set cutting conditions that match the material, giving consideration to the material's
thickness and type of material. The PNC-1860/1410/1210 has an internal "cutting test" to check the cutting conditions. This
"cutting test" allows you to determine settings for the cutting speed, blade force and the amount of offset.
Experiment with different settings for different types of material and adjust the configuration accordingly.
Procedure
(1) Install a blade and load a material, then close the front cover (see "3-2 Installing the
Cutter" to "3-3 Loading the Material).
Press the
key until the screen shown at right appears. Use the
MENU
keys to move the tool carriage to the place where the cutting test is to be performed. The
tool carriage cannot be moved by pressing the
display shows the screen right.
• Note that an area of approximately 2 square centimeters (a little less than a square inch) is
required to make a test cutout (given that the tip of the cutter after it has moved is at the
origin at lower-left).
(2) Press the
TEST
key for 0.5 seconds or more. Cutting test starts.
The resulting cutouts will then appear as illustrated.
(3) Confirm the cutting speed and the blade force. Peel off the round section
(marked by
(marked by
section (marked by
carrier paper, you have achieved optimum cutting speed and blade force.
(4) The remaining cross-shaped area is used to check whether
the offset value is set correctly. When the offset value has
been correctly set, the corners of the figure should appear
cleanly cut as shown in A of the figure below. If the offset
value is too small, the corners will appear slightly rounded
as illustrated by B; an offset value which is too large will
result in a cut figure similar to C.
If the material was not cut correctly in steps (1) through (4) of the cutting test, change the cutting conditions.
Repeat the cutting test and adjustment until the optimal cutting speed, blade force, and blade compensation are found.
Adjusting cutting speed • blade force • blade compensation
With a blade installed, a Material loaded, and the front cover closed, check to make sure that the screen shown below appears on
the display. If a different menu is displayed, press the
Blade compensation
Setting range: 0.00 mm (in increments
of 0.025 mm)
• Use the
and
keys to move the blinking cursor to the item to be set.
• Then use the
and
keys to change the numerical value, and press the
12
,
). Confirm that you can peel off the square section
), but do not remove it. Also remove the square
). If the blade leaves a slight trail on the
MENU
1 CUT
0.250mm
,
,
and
,
and
keys unless the
A
key until the screen shown below appears.
Cutting speed
50cm/s
30gf
Setting range: 1—85 cm/s.
Blade force
Setting range: 20—350 gf
key to enable the setting.
ENTER
ORIGIN SET->ENTER
O
0
Peel off first
Then, peel this off
Origin
(Position of the tool installed
in step 1)
B
C
(In increments of 1 cm/s)
(in increments of 10 gf)
Hide quick links:
Advertisement
Table of Contents
