Setting Up Material
Setting Up Flat Material
If flat material is used, it must be at least 70 mm (2.76 in.) longer than the vertical size of the cut data.
This is the length required for the grit roller to feed out the material to the front or rear.
Refer to the figure below and ensure that there are sufficient margins at the front and rear, the right and
left of the material.
50 mm (1.97 in.) or more
15 mm (0.60 in.) or more
25 mm (0.99 in.) or more
IMPORTANT
Materials with any of the following characteristics cannot be used: Uncurl and straighten the shape of the material be-
fore loading.
• The material is curled upward.
• The leading edge of the material is bent or creased.
1. Loading Flat Material
These instructions describe how to set A4 material.
Procedure
1.
Lower the loading lever.
IMPORTANT
Do not use excessive force when moving the loading lever.
Doing so may damage it.
28
Basic Operation