Uncut Areas Remain or Cut Edges Are Not Clean
Are the blade and blade holder securely installed?
Make sure the screws are tightened securely so that they do not come loose during cutting.
RELATED LINKS
・
P. 276Replacing the Blade
Is the tip of the blade broken?
If it is, replace the blade with a new one.
RELATED LINKS
・
P. 276Replacing the Blade
Is there any buildup of dust or material adhesive on the tip of the blade?
Remove and clean the blade.
RELATED LINKS
・
P. 276Replacing the Blade
Is there any buildup of pieces of material or dust inside the blade holder?
Take off the tip of the blade holder and remove any pieces of material or dust inside.
RELATED LINKS
・
P. 275Cleaning the Blade Holder Cap
Is a thick material being used?
When using thick material, set "QUALITY" to "HEAVY".
RELATED LINKS
・
P. 200Setting the Cutting Speed
Are the blade force and cutting speed appropriate?
Carry out cutting tests and adjust the settings until cutting can be performed adequately.
RELATED LINKS
・
P. 198Setting the Blade Force
・
P. 206Setting the Speed of the Blade During Cutting
・
P. 44Perform Test Cutting
282
Cutting Problems