Adjusting the Cut Setting
Cutting Corners Cleanly (Over Cut)
This function cuts extra at the start and the end of a cutting line. It is effective when you want to produce
particularly sharp corners, for example when cutting thicker materials. When cutting small characters or
complex shapes, this function is normally set to "OFF" to avoid cutting necessary parts of the material.
"ON"
Procedure
1.
Press [MENU] several times to display the following screen.
CONDITION
MEMO
When the material is loaded, press [MENU] several times to display the following screen.
UNSETUP
2.
Press [▼] several times to display the following screen.
OTHERS
3.
Press [▶].
4.
Press [▲][▼] to display the following screen.
OVER CUT OFF
5.
Press [▶].
6.
Press [▲] or [▼] to select "ON" or "OFF".
OVER CUT OFF
*OFF
210
Optimizing Cutting Quality
"OFF"