Table of Contents
Advertisement
• Other setting
ENGLISH JAPANESE GERMAN FRENCH SPANISH ITALIAN
Display readout
ENGLISH JAPANESE
GERMAN
FRENCH
Factory default setting
ENGLISH
Available settings
ENGLISH, FRENCH, GERMAN,
SPANISH, ITALIAN and JAPANESE
DISPLAY UNIT
Display readout
DISPLAY UNIT
<MACHINE> MILI
Factory default setting
MACHINE
Available settings
MACHINE / MILLIMETER
DEMO CUTTING MODE
Display readout
DEMO CUTTING
Factory default setting
—
UP/DOWN MOVE
Display readout
UP/DOWN->ENTER
MOVE
->CURSOR
Explanation
The PNC-1850/1200 is capable of displaying all its menus in either of six
languages, English, French, German, Spanish, Italian and Japanese.
Procedure
While holding down the
Using the
or
Setting the coordinate unit used for display
Explanation
This sets the type of unit for coordinate values that appear on the display. Set this
to "MECHANICAL UNIT" for display in cutting coordinate units (1 = 0.025 mm),
or to "MILLIMETER" for display in millimeters.
Procedure
At the top menu, press the
cursor to "SUBMENU" on the right side of the lower line of the display, press
, then press
ENTER
MENU
"UNIT" on the left side of the lower line of the display, and press
Change the value with
Performing demo cutting
Explanation
This performs an operation check when the PNC-1850/1200 is not working
correctly.
Procedure
* A computer is not required in order to carry out the self-test.
Refer to "1-4-2 Installing the cutter" and
install a blade holder in the tool carriage.
Hold down the
on the panel while you
turn the power ON.
Load the sheet, following the procedure
described in "1-4-3 Loading the sheet."
Close the front cover and use the display
menu to select the type of sheet loaded.
After sensing the sheet size, the PNC-
1850/1200 begins demo cutting.
Operation is normal if the figure shown at right is cut.
Moving the blade
Explanation
This moves the tool up or down. It also moves the tip of the blade in any of four
directions (-X, +X, -Y, or +Y).
With the tool down, the tool carriage can be moved with the four cursor keys to
cut the sheet.
Procedure
At the top menu, press the
blinking cursor to "SUBMENU" on the right side of the lower line of the display,
press
, then press
ENTER
To move the tool up or down, press
direction, press
,
Changing the language used for display
key, turn the power on.
MENU
to select. Press
to save the setting.
ENTER
key once. Press
MENU
twice. Use
or
to move the blinking cursor to
or
and press
to save the new setting.
ENTER
key once. Press
MENU
again.
MENU
ENTER
. To move in the -X, +X, -Y, or +Y
,
, or
, respectively.
or
to move the blinking
again.
ENTER
or
to move the
31
Hide quick links:
Advertisement
Table of Contents
