Print & Cut in Tool Mode
Tool Mode can be used in the following situations.
• When it is not possible to perform alignment in Sensor Mode
• When performing Print & Cut without selecting the type of material
MEMO
It is not possible to use Tool Mode when using only 3 crop marks.
Alignment tool
Step 1: Set the Alignment Method (Tool Mode)
Procedure
1.
Press [MENU] several times to display the following screen.
UNSETUP
2.
Press [▼] several times to display the following screen.
CROPMARK
<SENSOR MODE>
3.
Press [▶].
CROPMARK
SENSOR MODE
4.
Press [▲] or [▼] to select "TOOL MODE".
CROPMARK
TOOL MODE
5.
Press [ENTER].
CROPMARK
<TOOL MODE>
6.
Press [MENU] to return to the original screen.
Required items
Material on which tool marks have been printed ( )
173
Other Cutting