Printing And Cutting Are Misaligned; Is A Thick Material Being Used; Is The Machine Set To Feed Forward Some Amount Of Material Before Cutting - Roland VersaSTUDIO GS2-24 User Manual

Printing and Cutting Are Misaligned

RELATED LINKS
・
P. 215Adjusting the Cutting Position
・
P. 217Adjusting the Printing Position

Is a thick material being used?

When using thick material, set "QUALITY" to "HEAVY".
RELATED LINKS
・
P. 200Setting the Cutting Speed

Is the machine set to feed forward some amount of material before cutting?

When using roll material or flat material longer than 1.6 m (63.00 in.), if cutting is performed without the
material length required for the cutting data being fed forward, the material may slip or operation may
stop due to a motor error.
Set the machine so that the necessary amount of material is fed forward before cutting.
RELATED LINKS
・
P. 39Check Material Feeding
281
Cutting Problems