Cutting area
The material's lateral cutting area (direction in which the cutting carriage moves) is determined by the po-
sitions of the pinch rollers. The cutting area spans between the two pinch rollers, minus approximately 1
mm (0.04 in.) on each side.
Pinch roller
Cutting area
Cutting coordinate origin
A
Maximum 584 mm (22.99 in.)
Type of specified material
• "ROLL" / "EDGE"
B
• "PIECE"
C
10 to 25 mm (0.40 to 0.98 in.)
D
Approx. 1 mm (0.04 in.)
E
15 mm
F
50 mm (1.97 in.) or more
*1
The accuracy is guaranteed up to 1,600 mm (62.99 in.).
*2
If the detected length is 1,600 mm (63.00 in.) or longer, the material is determined as "ROLL", and the cutting area length will
be set to approximately 25,000 mm (984.25 in.). However, the display does not show the length.
328
Main Specifications
Max. 25,000 mm (984.25 in.)
*2
Max.: Detected length
*1