About The Cutting Area; Using The Display Menus - Roland PNC-1860 User Manual

5 ABOUT THE CUTTING AREA

Maximum cutting area
PNC-1860 : 1195 mm (W) x 24998 mm (L)
PNC-1410 : 889 mm (W) x 24998 mm (L)
PNC-1210 : 585 (W) mm x 24998 mm (L)
The cutting area along the horizontal plane (the direction in which the tool carriage moves) is determined by the position of the pinch
rollers. The workable area spans the length between the two rollers, minus a margin of about 1 mm (about 0.04") on both sides.
If the material length is greater than 1,600 mm (62-15/16") when a flat material (paper) has been loaded, the PNC-1860/1410/
1210 determines it to be a rolled material and sets the material length to 24,998 mm (984-1/8").

6 USING THE DISPLAY MENUS

This section describes the basic steps for using the display menus. Use this information together with "7 Display Menu Flowchart" on
the following page to make menu settings.
Use the and keys to move the blinking cursor (" ") and choose a setting.
Then use the and keys to change the value (or the selection) and enable the setting by pressing the
1 CUT 50cm/S
0.250
Press the
the next menu
AREA AXIS
REPLOT SUBMENU
Use the and
blinking cursor (" ") and choose a setting
Press the
ENTER
to the next setting screen
(47" x 984-1/8")
(35" x 984-1/8")
(23" x 984-1/8")
* The pairs of allows
indicate the positive
direction along the X
and Y axis.
Movable pinch roller (left)
10 mm
(3/8")
Approx. 15 mm
(about 9/16")
Cutting coordinates origin (0,0)
30gf
key to change to
MENU
Select "AREA"
MENU
keys to move the
key to advance
Acceptable material widths
PNC-1860 : 90—1372 mm (3-1/2"—54" )
PNC-1410 : 90—1067 mm (3-1/2"—42" )
PNC-1210 : 50—762 mm
1195 mm (47")
PNC-1860
889 mm (35")
PNC-1410
585 mm (23")
PNC-1210
Sheet
Cutting area
Approx. 1 mm
(about 0.04")
• To return to the menu selection screen from any of the menu
value setting screens, press the
• To return to the previous screen without changing the numerical
settings, pressing the
key.
AREA LENGTH
MOVE <1.0m>
Then use the and keys to change the value and
enable the setting by pressing the
The value enclosed in angled brackets ("<>") is the current setting
ROTATE
<0deg> 90deg
Use the and keys to move the blinking cursor
(" ") and choose a setting
The selection enclosed in angled brackets ("<>") is the current setting
24998 mm (984-1/8")
Movable pinch roller (right)
ENTER
key.
MENU
key without pressing the
MENU
ENTER
key
(1-15/16"—30" )
key.
ENTER
17