Table of Contents
Advertisement
Cutting area
The cutting area along the material's horizontal plane (the direction in which the cutting carriage
moves) is determined by the position of the pinch rollers set up on both edges of the material. When
printing and cutting use crop marks, the maximum area in the vertical and horizontal directions is re-
duced by an amount equal to the crop mark size and margin.
Pinch roller
Cutting area
Cutting coordinates origin
A
64-inch model: Max. 1,627 mm (64 in.), 54-inch model: Max. 1,372 mm (54 in.)
B
Max. 50,000 mm (1,968 in.)
Material length (B) is no more than 4,000 mm (157.48 in.): 0.5 to 25 mm (0.02 to 0.98 in.)
C
Material length (B) is more than 4,000 mm (157.48 in.): 25 mm (0.99 in.) or more
D
Approx. 1 mm (0.04 in.)
E
Min. 20 mm (0.79 in.)
F
Min. 80 mm (3.15 in.)/50 mm (1.97 in.)
*1
Refer to "Specifications" in the Setup Guide for information on the range of assured accuracy.
*2
When extended in the feed direction (length)
*1
*2
Material Used and Cuttable Area
Basic Information
11
Advertisement
Table of Contents
