Details Of The Origin-Point Location And Cutting Area - Roland Camm-1 Pro GX-500 User Manual

4-2 Details of the Origin-point Location and Cutting Area

The Location of the Origin Point Immediately After Loading Material
With this machine, the initial origin point is determined when you load material and press the [ENTER] key. This origin point differs
according to the selection made for [SELECT SHEET] on the operation panel when loading material.
[ROLL]
[F-EDGE]
[R-EDGE]
[PIECE]
For more information, see the following page.
* When [ROTATE] is set to [90deg], the initial origin point is set at the lower right with the X and Y axes rotated 90 degrees.
34
Set near the left-hand pinch roller
Set at the front left edge of the material
Set at the inner left edge of the material (When using the "Front loading")
Material size is detected and the origin is set at the lower-left area of the material