Printing And Cutting Are Misaligned; Is A Thick Material Being Used; Is The Sensor Reading Inaccurate; Was The Machine Set To Feed Forward Some Amount Of Material Before Cutting - Roland Camm-1 GR2-640 User Manual

Printing and Cutting Are Misaligned

Is a thick material being used?

Correct the cutting length according to the material actually used.
RELATED LINKS
・ P. 117 "Correcting Distance during Cutting Based on the Thickness of Material"

Is the sensor reading inaccurate?

The AAS sensor's reading of crop marks may be out of position due to long-term use or a strong impact
on the machine.
Run an AAS offset test.
RELATED LINKS
・ P. 142 "Running an AAS Offset Test"

Was the machine set to feed forward some amount of material before cutting?

When using roll material or flat material longer than 1.6 m (63.00 in.), if cutting is performed without
the material length required for the cutting data being fed forward, the material may slip or operation
may stop due to a motor error.
Set the machine so that the necessary amount of the material is fed forward before cutting.
RELATED LINKS
・ P. 130 "Preventing Positioning Errors by Setting Material Feeding"
Output Quality Problems
155