Loading Flat Material (Standard-Size Material, Cut Material, Etc.) - Roland CM-500 User Manual

7
Use the control panel to make the following setting.
SELECT SHEET
ROLL EDGE PIECE
Press or
select [ROLL].
Press
PRESS SETUP KEY
Press
WIDTH LENGTH
14612 ------
Press

Loading Flat Material (Standard-size Material, Cut Material, Etc.)

• If the material tends to reroll in the direction of its top surface (the cutting surface), roll the material in the other
direction so that its backing paper is bent inward. If you perform cutting without changing the direction of the crease,
the material may rise up during cutting and become caught on the front cover.
• If the material strikes the shaft during cutting, remove the shaft.
1
Lower the sheet loading levers and pass the material
between the pinch rollers and the grit rollers.
2
Follow steps 4, 5, and 6 of " Loading Roll Material" to load a piece of material.
3
Close the front cover.
Use the and keys to select [PIECE], then press the
4
Press the key. The tool carriage will move from side to side and the material
will move forward and backward to detect the size of the material.
When sensing ends, the display shows the loaded material size.
If a pinch roller is positioned over an area where there is no grit roller, the
message shown at right appears when you press the
If this occurs, lower the sheet loading levers and move the pinch rollers to the
proper positions above the grit rollers.
Reposition the material to match this new alignment, then lower the sheet
loading levers to hold the material in place.
When detecting the material size in step 4, if the material is misaligned and looks like it might come loose from the pinch rollers, or
actually does come loose, please reload the material.
1 CUT
0.250mm
to
Press
AREA AXIS
.
REPLOT SUBMENU
Press
select [AREA].
.
Press
The set length of material is fed out.
.
Make sure that the material remains held by the pinch rollers.
If the material does come loose from the pinch rollers, set it in place again.
50cm/s AREA
30gf MOVE
Press
.
Press
AREA
MOVE
or to
Press
select [MOVE].
.
Press
key.
key.
LENGTH
< 1.0m>
or to select the value.
or to change the value.
LENGTH
< 2.0m>
Set this to the
or to
length of the
material to be
cut.
.
Pass the material
Close the front cover
SELECT SHEET
ROLL EDGE PIECE
PRESS SETUP KEY
WIDTH LENGTH
28920 150
Change Pinch
Roller Position
19