Cutting The Corners Longer To Make It Easy To Detach Cutting Data (Over Cut) - Roland Camm-1 GR2-640 User Manual

Cutting the Corners Longer to Make It Easy to
Detach Cutting Data (Over Cut)
Cutting the top left corner of the cutting line slightly longer makes it easy to peel off the sticker. If
the over cut function is enabled when cutting small characters or complex shapes, areas of the materi-
al that are required may be cut. Therefore, this function is turned off for normal use.
Procedure
1.
Press [TOOL SELECT].
If material is loaded, press [ON/OFF LINE] to switch to offline mode.
2.
Press [▶] to display the screen shown below.
The current value is displayed on the screen.
Over Cut
Select:
3.
Press [▲] or [▼] to enter the over cut length.
4.
Press [ENTER] to confirm your entry.
5.
Press [ON/OFF LINE] to go back to the original screen.
MEMO
• Default setting: 0.00 mm
• Setting range: 0.00 to 3.00 mm (0.00 to 0.12 in.) (changeable in 0.05 mm [0.01 in.] increments)
0.00 mm
OK:ENTER
Optimizing the Output Quality
113