Adding The Fusing Oil - Minolta CF910 Service Manual

Hide thumbs Also See for CF910:

Table of Contents

15. Holding Plate

Support plate

(3) Adding the Fusing Oil

At reinstallation, visually check that:

• The blade is on the dowel by checking

• The blade is not waved.

Face the blade as shown.

Never mind about the front

and back sides of the blade.

16. Oil Regulating Blade

Clean/replace.

through the check hole.

1. Fit the spout to the oil can, remove the

cap from the Fusing Unit Oil Tank, then

pour oil into the tank.

2. Fill the tank until the oil level is within

the shaded area.

Table of Contents