Minolta CF910 Service Manual page 486

3-8. MACHINE ADJUST MODE
(1) Accessing the Machine Adjust Mode
1. Open "CF911P" in the menu bar on the PC and click "Serviceman Mode."
2. Select "Machine Adjust" from the Serviceman mode menu.
(2) Fuser NIP
NOTE
After Fuser Nip is adjusted, Fuser Speed must also be adjusted.
Reference
The Fusing Roller pressure adjusting screws can be adjusted by removing the Left Middle
Cover.
1. Place A4 crosswise paper in either one of
the drawers or on the Multi Bypass Table.
2. Open the Front Door and slide out the
Transfer Drum Unit.
3. From the position where the Fusing Roller
pressure adjusting screws are fully tight-
ened, back them off four turns, ensuring
uniform pressure on the front and rear
ends.
4. Slide the Transfer Drum Unit back into the
printer.
5. Close the Front Door.
D-116
-12-