Table of Contents
Advertisement
3-9.
DEVELOPER CHANGE MODE
Developer Change
(1)
(Developer Discharge
Note
Although functions are available to perform Developer Discharge, Developer Filling, or
Developer Agitating individually, perform "Developer Change" that covers all these in a
given sequence.
1. Turn OFF the Power Switch.
2. Open the Front Door, remove the Developing Unit Cover, and slide out the Developing
Unit.
3. Install the Jumper Harness and Mag. Roller Shields.
Developer Filling
Only plug in the
Small Connector.
Mag. Roller Shield ×4
4. Turn ON the Power Switch.
5. Open "CF911P" in the menu bar on the
PC and click "Dev Mode."
6. Open and close the Front Door.
7. Install the Interlock Switch Actuating Jig.
8. Select "Developer Change".
D-131
-13-
Developer Agitating)
Advertisement
Chapters
Table of Contents
Troubleshooting
