Flash Memory - Minolta CF910 Service Manual

4-3.

FLASH MEMORY

Software has conventionally been upgraded by replacing ROM on each board. This copier
employs flash memory for the system control IC mounted on the IR Control Board. Its con-
tents are reprogrammed easily by performing the following steps using the IC card (mem-
ory card), into which data has been previously downloaded.
NOTE:
NEVER remove or insert the memory card with the copier power turned ON.
Fig. 2
Fig. 1 Memory Card Installation Position
Insert the memory card into the specified
position on the IR Control Board.
Memory Card Cover
Fig. 1
1154D274AB
1154D275AA
D-150
1. With the Power Switch in the OFF posi-
tion, unplug the power cord from the
power outlet.
2. Remove the Hopper Unit.
3. Remove the two screws that secure the
Memory Card Cover.
4. Install the Memory Card. See Fig. 1.
5. Plug the power cord into the power outlet.
6. Turn ON the Power Switch.
This rewrites the data.
7. On the Touch Panel, make sure that the
data has been properly written. See Fig.
2.
8. Unplug the power cord from the power
outlet.
Do not turn OFF the Power Switch at this
time.
9. Remove the memory card.
Fig. 2
1154D277AA