Removal Of The Fusing Roller Heater Lamp, Right Fusing Roller, And Left Fusing Roller - Minolta Di200 Service Manual

FrameMaker Ver.5.5E(PC) Di200/Di251/Di351 DIS/REASSEMBLY, ADJUSTMENT
01.02.09
(2) Removal of the Fusing Roller Heater Lamp, Right Fusing Roller, and Left Fus-
ing Roller
1. Remove the Fusing Unit.
Where Fusing Front Cover
is Mounted
4011D065AA
4011D067AA
2. Open the Exit Cover.
3. Remove three screws and the Fusing Front
Cover.
NOTE
• After the Fusing Front Cover has been installed,
insert a screwdriver through the hole in the Fusing
Front Cover and move the ends of the flat spring in
the direction of the arrow so that they rest on the
bearing outer race side face.
Where Ends of Flat Spring
are Moved
4. Remove one cord holder and the harness.
5. Remove two screws, six cord holders, and the
harness.
D-28
Ends of Flat
Spring
Bearing Outer
Race Side Face
4011D064AB