Minolta CF910 Service Manual page 338

Service Mode Menu
Touch Panel Display
CH Cleaning
OHP Speed
Transfer Table
Editor Screen
A6 Card Margin
Setting
Setting (the default setting is
Select whether or not to clean the PC Drum Charge Corona wire after
the Power Switch has been turned ON, the Front Door has been
opened and closed, and after image stabilization control following the
completion of the copy cycle making the 100th copy.
ON
Vary the system speed to obtain good image quality of copies made
on OHP transparencies.
-4 -3
Slower
Vary the transfer table from 1 to 3 in order to prevent poor image
transfer from occurring when the level of triboelectric charge of the
toner is reduced by deteriorating developer or using specific types of
paper.
Note
Change this setting when the count of the C Developing Unit of Life
Counter 3 reaches 15K.
- Inch Areas -
When the Image Edit Board is mounted on the copier, the "Editor
Screen" key appears on the "Setting" screen of the Service mode of
the copier. When this key is selected, options are given for "Set/
Unset." Be sure to select "Set" at all times.
- Metric Areas -
A different setting is necessary for the "Editor Screen" function avail-
able from the "Setting" screen of the Service mode of the copier,
depending on whether only an E-2M is mounted or E-2 is mounted (or
when adding an E-2D to E-2M). Here are the details of the setting
requirements:
Set
Unset
Set the void image width on the top and left edges when cards are fed
through the copier.
-Left Margin-
3mm
-Top Margin-
5mm
... ±0 ...
2
1
E-2 (E-2D added to E-2M)
E-2M only
4mm
6mm 7mm
S-25
Highlighted
)
OFF
+3 +4
Faster
3
5mm
8mm