Minolta CF910 Service Manual page 279

3. Press the Start key to feed paper through the copier to determine if an adequate length
of loop is formed before the Fusing Rollers.
1154D215AA
Retarded
The loop length is too long
causing the paper to have
too much slack.
1154D212AA
Correct
A good length of loop is
formed as the paper moves
into the Fusing Rollers.
4. If the timing is advanced or retarded,
Adjustments
Retarded: Increase the setting.
Advanced: Decrease the setting.
5. Check the length of loop again and
1154D266CA
6. Using the same procedure, adjust for
7. After the adjustments have been
D-118
Advanced
No loop is formed causing the
paper to be taut.
change the setting of Fuser Speed.
repeat the above steps until a good
length of loop is obtained.
"Heavy Stock 2 and OHP Film".
made, touch "Ex.".
1154D213AA