Minolta CF910 Service Manual page 281

Note:
Transfer Output Order
Transfer No. First ..........Cyan
Second ......Magenta
Third ..........Yellow
Fourth ........Black
1154D086CA
1154D087CA
1154D109CA
D-120
4. For Poor Image Transfer or Excessive
Image Transfer, touch the "Ex" key twice
to return to the Service Mode menu
screen.
5. Select "Machine Adjust" and then
"Transfer Output."
6. Touch "Normal" and "First" (image trans-
fer number), in that order, and change
the setting as necessary using the shift
keys ( or ).
Adjustments
Excessive Image Transfer: Decrease the
setting.
Poor Image Transfer: Increase the setting.
7. Select the following functions again in
this order: "Factory Test Print," "Grada-
tion Pattern," and "Belt Pattern Cyan."
Then, press the Start key.
8. Check the test print again.
9. After the adjustment has been made,
select "Machine Adjust" and "Transfer
Output" again and, using the shift keys
( or ), set the same value as that for
"First" of "Normal" for "Second," "Third,"
and "Fourth."
10. Make the following function selections in
this order: "Factory Test Print," "Grada-
tion Pattern," and "4 Color." Then, press
the Start key.
11. Make the final check on the test print fed
out onto the Exit Tray.
12. If Poor Image Transfer or Excessive
Image Transfer is evident on magenta,
yellow, or black on the test print, make
an independent setting for Second,
Third, or Fourth.
13. Using these procedures, make adjust-
ments for "2-Sided" and "OHP Film,"
sequentially.
14. After the adjustments have been made,
touch "Ex.".