Minolta CF910 Service Manual page 192

15. Fusing Entrance Guide
Note
16. Lower Fusing Roller
Replace.
(Rear of Copier)
NOTE:
When mounting the Fusing Entrance Guide, make sure that the guide is in complete
alignment with the positioning plates, having no clearance from, or overlap with, the
positioning plates.
Positioning Plate
Fig. 5
The bushing for the front side is not the
same as that for the rear side.
One for the front
side = 17 mm
One for the rear
side = 12.5 mm
1144D031AA
D-31
Lower Fusing Roller Bushing ×2
Replace.
Fig. 5
14. Harness Cover
Paper Separator Fingers × 10
Clean.
Fusing Entrance Guide
Positioning Plate
Fig. 6
Bearings (front and rear) installed
positions
Flange
Lever
Bearing
Fig. 6
(Front of Copier)
1154D224AE
1154D295AA
Frame
1144D033AA