(3) Adjustment of the Gap Between the Doctor Blade and Sleeve Roller
Toner Scattering Prevention Plate
Fig. 1 Adjusting Procedure
Doctor Blade
<Rear>
Developer Supply Roller
1. Remove the Toner Scattering Prevention Plate.
2. Remove the Doctor Blade.
3. Clean the Developer Supply Roller.
4. Refit the Doctor Blade and temporarily secure it.
5. Install the Doctor Blade-Sleeve Roller Gap Adjusting Jigs and, with the Doctor
Blade pushed up, tighten the adjusting screws.
NOTE
Make sure that there are no foreign objects wedged between the Doctor Blade-Sleeve
Roller Gap Adjusting Jig and Sleeve/Magnet Roller.
Doctor Blade-Sleeve Roller
Gap Adjusting Jig ×2
D-140
Doctor Blade
Fig. 1
Developer Supply Roller
1144D222AA
<Front>
Adjusting Screw
1144D221AA