Fuser Speed - Minolta CF910 Service Manual

(3) Fuser Speed

Notes
1. This adjustment should be made after Fuser NIP has been adjusted.
2. A particular paper source and type of paper must be used for each speed function as
follows:
• CF Paper. 120 mm/s:
Select any of the drawers loaded with A3 lengthwise or 11" × 17" CF paper.
• Heavy Stock 2. 50 mm/s:
Place A3 lengthwise or 11" × 17" thick paper weighing 157 g/m
Table.
• OHP Film. 80 mm/s:
Place A4 lengthwise or 8-1/2" × 11" OHP transparencies on the Multi Bypass Table.
6. Select "Fuser NIP" from the Machine
7. Press the Start key.
8. Measure the width of the area of con-
9. If the measurement falls outside the
1154D082CA
Specifications
Width of area of contact ... 6 ±0.3 mm
Difference in width between front and rear
... Within 0.3 mm
Adjustments
> 6.3 mm ... Loosen the adjusting screw.
< 5.7 mm ... Tighten the adjusting screw.
10. After the adjustments have been
1. Select a drawer that is loaded with A3
2. Select "Fuser Speed" and then "CF
1154D083CA
D-117
Adjust mode menu.
tact between the Upper and Lower
Fusing Rollers (NIP) at the front and
rear ends of the copy fed out onto the
Exit Tray.
specified range, turn the Fusing Roller
pressure adjusting screws as neces-
sary.
made, touch "Ex.".
2
on the Multi Bypass
lengthwise or 11" × 17" paper.
Paper".