Machine Adjust Mode; Accessing The Machine Adjust Mode; Fuser Nip - Minolta CF910 Service Manual

3-8.

MACHINE ADJUST MODE

(1) Accessing the Machine Adjust Mode

1. Press the User Mode key on the control panel to open the User Mode screen. Then,
touch [Meter Count] to open the Meter Count screen.
2. Press the following keys in this order to set the copier into the Service mode: Stop
0 0 Stop
3. Select "Machine Adjust" from the Service mode menu screen.

(2) Fuser NIP

NOTE
After Fuser Nip is adjusted, Fuser Speed must also be adjusted.
Reference
The Fusing Roller pressure adjusting screws can be adjusted by removing the Left Middle
Cover.
0 1.
1154D079CA
1144U017AA
D-116
1. Place A4 crosswise paper in either one of
the drawers or on the Multi Bypass Table.
2. Open the Front Door and slide out the
Transfer Drum Unit.
3. From the position where the Fusing Roller
pressure adjusting screws are fully tight-
ened, back them off four turns, ensuring
uniform pressure on the front and rear
ends.
4. Slide the Transfer Drum Unit back into the
copier.
5. Close the Front Door.
1154D080DA
1144D254AA