Adjustment Of Belt Tension - Minolta CF910 Service Manual

3-5.

ADJUSTMENT OF BELT TENSION

Tip
A given tension is being applied to the torsion spring or tension spring fitted to the tension
plate that keeps each timing belt taut. Belt tension adjustment can therefore be made by
simply loosening and tightening the mounting screw(s).
No. Driven Mechanism
1 Developing Unit
2 Carrier Retriever
3 Hopper
4 Paper Take-Up
5 Cleaning Unit
6 Scanner Drive
Example
Adjustment of Hopper Unit Timing Belt
Loosen the two tension plate mounting screws and then tighten them again.
Loosen one tension plate mounting screw and then tighten it again.
Loosen one tension plate mounting screw and then tighten it again.
Loosen two tension plate mounting screws and then tighten
them again.
Loosen two tension plate mounting screws and then tighten
them again.
Loosen two tension plate mounting screws and then tighten
them again.
Loosen three Scanner Drive Motor mounting screws and
then tighten them again.
D-111
Adjusting Procedure
1154D210AB