Minolta CF910 Service Manual page 492

4-3. FLASH MEMORY
Software has conventionally been upgraded by replacing ROM on each board. This printer
employs flash memory for the system control IC mounted on the IR Control Board. Its con-
tents are reprogrammed easily by performing the following steps using the IC card (mem-
ory card), into which data has been previously downloaded.
NOTE:
NEVER remove or insert the memory card with the printer power turned ON.
Fig. 1 Memory Card Installation Position
Insert the memory card into the specified
position on the IR Control Board.
1. With the Power Switch in the OFF posi-
Memory Card Cover
2. Remove the Hopper Unit.
3. Remove the two screws that secure the
4. Install the Memory Card. See Fig. 1.
5. Plug the power cord into the power outlet.
6. Turn ON the Power Switch.
7. On the PC screen, make sure that the
Fig. 1
8. Unplug the power cord from the power
9. Remove the memory card.
D-150
-18-
tion, unplug the power cord from the
power outlet.
Memory Card Cover.
This rewrites the data.
data has been properly written. See Fig.
2.
outlet. Do not turn OFF the Power Switch
at this time.
Fig. 2 Displayed on PC screen in Pro-
gram Transfer Mode of the "FACTE.exe"
software.