Developing Unit; Replacement Of The Atdc Sensor; Cleaning Of The Ds Rolls, Toner Scattering Prevention Seal 1 And Toner Scattering Prevention Plate; Replacement Of The Toner Collecting Box, Air Filter, And Ozone Filter - Minolta CF910 Service Manual

2-6.

DEVELOPING UNIT

(1) Replacement of the ATDC Sensor

Note:
After replacing the ATDC Sensor
window, check that the window
makes full cotact with the terminal
by testing for conductance using
a volt-ohm meter. (See the
illustration.)
(2) Cleaning of the Ds Rolls, Toner Scattering Prevention Seal 1 and Toner
Scattering Prevention Plate

(3) Replacement of the Toner Collecting Box, Air Filter, and Ozone Filter

1. Toner Collecting Box
Replace.
Note
1. Toner Scattering Prevention Plate
1144D095YA
4. Mounting Bracket
D-44
2. ATDC Sensor Window
Replace.
1. ATDC Sensor Assy
1144D094AA
2. Ds Roll ×2
Clean (Developing Unit M/C/Bk)
Toner Scattering Prevention Seal 1
Clean. (Y Developing Unit only)
3. Air Filter
2. Cover Plate
1144D078YB
5. Ozone Filter
Replace.
Clean.
Replace.