Minolta CF910 Service Manual page 288

3. Dup. Left-Margin
This function is used after the PH has been replaced or when the reference position of the
Duplex Unit deviates due to variations in size of paper.
3±1.5mm
5. If the measurement falls outside the spec-
ified range, change the setting using the
shift keys (
Adjustments
If the setting is longer, decrease it.
If the setting is shorter, increase it.
6. Make a test copy to check again.
7. Using these steps, adjust the remaining
1154D094CA
drawers and the Multi Bypass Table (A4
crosswise or 8-1 /2" × 11").
8. After the adjustments have been made,
touch "Ex.".
1. Access the "PRT Area" screen.
2. Select "Dup. Left Margin" and then
"Upper."
3. Press the Start key.
1154D095CA
4. Measure the width of the void image on
the test copy as shown on the left.
Specifications
Void Image Width: 3±1.5 mm
1144D238AA
D-127
or ).