Minolta CF910 Service Manual page 167

No. Name
1 Front Door
2 Control Panel Unit
3 Original Glass
4 Upper Right Cover
5 Right Upper Cover
6 Right Lower Cover
7 Front Lower Cover
8 3rd Drawer
9 2nd Drawer
10 1st Drawer
11 Upper Rear Cover
12 Original Width Scale
13 Upper Left Cover
14 Left Upper Cover
15 Left Middle Cover
16 Exit Cover
17 Left Front Lower Cover
18 Multi Bypass Unit
19 Left Rear Lower Cover
20 Rear Cover
21 Toner Collecting Box
Cover
Removal Procedure
Remove No. 5. → Open and then remove the Front
Door.
Open Original Cover. → Open No. 1. → Remove No. 4,
13. → Remove No. 12. → Remove two magnet
catches. → Remove two screws that secure the Con-
trol Panel Unit.
Remove No. 13. → Remove No. 12.
Installation Tip:
Fit the Original Glass into the groove in the Original
Scale and fit the glass into the Glass Restriction Plate.
Remove two screws that secure the Upper Right
Cover.
Remove No. 4. → Remove four screws that secure the
Right Upper Cover.
Remove No. 4,5. → Remove five screws that secure
the Right Lower Cover.
Slide out 3rd Drawer. → Remove two screws that
secure the Front Lower Cover.
Slide out the drawer. → Remove the stopper. → Pull
out the drawer while slightly lifting it.
Remove Original Cover. → Remove two Hinge Covers.
→ Remove No. 4,13. → Remove No. 21. → Remove
No. 20. → Remove No. 5,14. → Remove six screws
that secure the Upper Rear Cover.
Remove No. 13. → Remove two screws that secure
the Original Width Scale.
Remove two screws that secure the Upper Left Cover.
Remove No. 13. → Remove No. 16. → Remove No.
15. → Remove six screws that secure the Left Upper
Cover.
Remove No. 16. → Remove two screws that secure
the Left Middle Cover.
Remove two screws that secure the Exit Cover.
Remove two screws that secure the Left Front Lower
Cover.
See p. D-14.
Remove two screws that secure the Left Rear Lower
Cover.
Remove No. 21. → Remove six screws that secure the
Rear Cover.
Remove one screw that secures the Toner Collecting
Box Cover.
D-6