Minolta CF910 Service Manual page 377

<Troubleshooting Procedure>
Symptom Step
• Paper is at a
1
stop at the
Paper
Take-Up
Sensor.
2
3
4
5
6
Check Item
Are the Paper Take-Up Roll and
Paper Separator Roll deformed,
worn, or dirty with paper dust?
Are the paper take-up/vertical
transport guide plates deformed
or dirty?
Where is the misfeed?
Is Upr-Trans (PC12) operational
as checked with "Switch 1
(Paper)"?
Is Mid-Trans (PC13) operational
as checked with "Switch 1
(Paper)"?
Is Lwr-Trans (PC14) operational
as checked with "Switch 1
(Paper)"?
T-11
Result Action
YES Clean or change the
Paper Take-Up Roll
and/or Paper Separator
Roll. ("Feed Motor
Speed" of "Machine
Adjust")
YES Correct, clean, or
change the defective
guide plate.
In the Upper Drawer:
Go to step 4.
In the Middle Drawer:
Go to step 5.
In the Lower Drawer:
Go to step 6.
NO Check the PC12 actua-
tor for operation and, if
it is okay, change
PC12.
NO Check the PC13 actua-
tor for operation and, if
it is okay, change
PC13.
NO Check the PC14 actua-
tor for operation and, if
it is okay, change
PC14.