Test Print; Gradation Adjust - Minolta CF910 Service Manual

(7) Test Print

• This mode is used to make test prints for adjusting and checking the image.
<Test Print Output Procedure>
• Select the desired Test Print function and press the Start key. This causes the copier to
automatically select the maximum size of paper loaded in the drawers and starts the test
print.
Note
The numbers shown on the upper-right corner of each function screen mean the following:
"1" is LIMOS1 and "2.5" is LIMOS2.5. The test print output represents the corresponding
image processing system selected.
Service Mode Menu
Touch Panel Display
Gradation Pattern Use to output a test pattern for each Developing Unit to check for
Halftone
Lattice Pattern
Solid Pattern
Color Sample

(8) Gradation Adjust

• This mode is used to automatically adjust the γ curve, which can be started by the press
of the Start Key.
Test Print
image and other parameters.
Use to output a halftone pattern for each color to check for image and
other parameters.
Use to output a lattice pattern for each color to check for image and
other parameters.
Use to output a solid black pattern to check for image and other
parameters.
Use to output a mono-color/base-color sample that can be output by
the copier to check for image and other parameters.
Setting
S-44