Installing An M320 Sib; Figure 89: Removing A Sib - Juniper M320 Hardware Manual

Installing an M320 SIB

Copyright © 2010, Juniper Networks, Inc.
Flip the ejector handles outward to unseat the SIB.
5.
Grasp both ejector handles, pull firmly, and slide the SIB about three-quarters of the
6.
way out of the chassis.
Place one hand underneath the SIB to support it, and slide it completely out of the
7.
chassis. Place it on the antistatic mat.
CAUTION: Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.

Figure 89: Removing a SIB

To install a SIB into the rear of the chassis (see Figure 90 on page 174):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Place one hand underneath the SIB to support it. With the other hand, hold one of the
2.
ejector handles on the SIB faceplate.
Carefully align the sides of the SIB with the guides inside the chassis.
3.
Slide the SIB into the chassis, carefully ensuring that it is correctly aligned.
4.
Grasp both ejector handles and press them inward to seat the SIB.
5.
Tighten the captive screws on the ejector handles.
6.
Chapter 13: Replacing the M320 Router Hardware Components
173