Installing A Txp-T1600 Sib - Juniper T1600 Hardware Manual

T1600 Core Router Hardware Guide

Installing a TXP-T1600 SIB

234
Grasp both ejector handles, pull firmly, and slide the SIB about three-quarters of the
10.
way out of the chassis.
Place one hand underneath the SIB to support it and slide it completely out of the
11.
chassis. Place it on the antistatic mat.
CAUTION: Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
Figure 134: Removing a TXP-T1600 SIB
Each TXP-T1600 SIB weighs approximately 10.2 lb (4.6 kg). To install a TXP-T1600 SIB
(see Figure 135 on page 236):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis. For more information about ESD,
see "T1600 Preventing Electrostatic Discharge Damage" on page 312.
Place one hand underneath the TXP-T1600 SIB to support it. With the other hand,
2.
hold one of the ejector handles on the TXP-T1600 SIB faceplate.
Carefully align the sides of the TXP-T1600 SIB with the guides inside the chassis.
3.
Slide the TXP-T1600 SIB into the chassis, carefully ensuring that it is correctly aligned.
4.
Grasp both ejector handles and press them inward to seat the TXP-T1600 SIB. Ensure
5.
that the ejector handle tabs are properly mated inside their corresponding chassis
Copyright © 2010, Juniper Networks, Inc.