Removing Temporary Idp Package Installation Files; Diagnostic Tests - Juniper LN2600 Manual

Rugged security router

Hide thumbs Also See for LN2600:

Table of Contents

Removing Temporary IDP Package Installation Files

Documentation

Documentation

The

fs_clean_boot

option does not remove temporary files left over from the IDP security

package installation. To remove the temporary files, run the separate IDP cleanup request

after installing or upgrading the IDP package:

user@ln1000>request security idp storage-cleanup downloaded-files

Successfully deleted downloaded secdb files

user@ln1000>

Powering On the LN1000–V Mobile Secure Router

Diagnostic Tests

LN1000-V Router Power Requirements

Startup power-on self-test (SPOST) and power-on self-test (POST) diagnostic tests

run automatically on the LN2600 router as part of the boot-up process at every power-on,

reset, or warm reboot. SPOST diagnostics consist of a limited suite of quick diagnostics

that ensure that system components required for Boot Loader and diagnostics relocation

and execution from RAM are working without error. POST diagnostics consist of a suite

of quick diagnostics that ensure that components of the system are working without

error before trying to load and execute Junos OS. PASS/FAIL test results for the SPOST

and POST diagnostics are reported by means of the front panel LED and console port.

In the event that SPOST, POST, or the bootstrap sequence reports a failure and the front

panel LED lights red, extended diagnostic tests are available.

In the event of failure of any hardware component, run the diagnostic tests from the

BOOT prompt.

For information about running extended diagnostic tests and other hardware issues,

contact Juniper Networks.

LN2600 Router Status LED on page 8

Chapter 13: Troubleshooting Router Boot-Up and Operation

Table of Contents