Removing Temporary Idp Package Installation Files - Juniper LN1000 User Manual

Removing Temporary IDP Package Installation Files

Related
Documentation
Accessing the Extended Diagnostic Tests
Filesystem cleanup skipped - NVMRO Read-only
Loading configuration ...
....
No files are deleted when NVMRO is set to
setting.
After the system completes its boot process, you can review the list of removed files by
reading the file_cleanup.log
root@ln1000% cat /var/tmp/file_cleanup.log
/cf/var/log/appidd
/cf/var/log/bin_messages
/cf/var/log/chassisd
/cf/var/log/cosd
/cf/var/log/dcd
.....
/cf/var/tmp/policy_status
/cf/var/tmp/rtsdb/if-rtsdb
/cf/var/tmp/spu_kmd_init
/cf/var/tmp/vpn_tunnel_orig.id
root@ln1000%
To determine the value of the
root@ln1000% sysctl kern.fs_clean_boot
kern.fs_clean_boot: 1
root@ln1000%
The fs_clean_boot option does not remove temporary files left over from the IDP security
package installation. To remove the temporary files, run the separate IDP cleanup request
after installing or upgrading the IDP package:
user@ln1000>request security idp storage-cleanup downloaded-files
Successfully deleted downloaded secdb files
user@ln1000>
Powering On the LN1000 Mobile Secure Router on page 25
SPOST and POST Diagnostic Tests on page 35
LN1000 Router Power Requirements on page 13
From the bootstrap prompt, you can enter the Diagnostic CLI menu interface and navigate
through the interface to execute diagnostic commands. Otherwise, you can use command
scripting at the bootstrap prompt.
The Diagnostic CLI menu interface combines all diagnostic tests and flags into a menu
structure that is easy to navigate and provides access to all available diagnostic
commands. You enter the Diagnostic CLI menu interface from the bootstrap prompt,
BOOT>, by entering the diags
Chapter 8: Troubleshooting Router Boot-Up and Operation
Read-only
file:
environmental variable using the CLI:
fs_clean_boot
command.
regardless of the
fs_clean_boot
41