Table of Contents
Advertisement
Step 6: Ground the TX Matrix Plus Router
Step 7: Set the TX Matrix Plus Configuration Size and Switch Fabric Chassis Number
Copyright © 2015, Juniper Networks, Inc.
You ground the TX Matrix Plus router by attaching a grounding cable to the chassis. You
must provide the grounding cable (the cable lugs are supplied with the router).
To ground the TX Matrix Plus router:
Connect the grounding cable to a proper earth ground.
1.
Verify that a licensed electrician has attached the cable lug provided with the TX
2.
Matrix Plus router to the grounding cable.
Make sure that grounding surfaces are clean and brought to a bright finish before
3.
grounding connections are made.
Place the grounding cable lug over the grounding points on the bottom rear of the
4.
chassis. The bottom pair is sized for M6 screws, and the top pair is sized for UNC 1/4-20
screws.
Secure the grounding cable lug to the grounding points, first with the washers, then
5.
with the screws.
Verify that the grounding cabling is correct, that the grounding cable is not touching
6.
or blocking access to TX Matrix Plus components, and that it does not drape where
people could trip on it.
The
SFC CHASSIS NUMBER
on the left side of the craft interface. To set the
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Using a Phillips (+) screwdriver, number 2, loosen the screw for the cover over the
2.
SFC CHASSIS NUMBER
Verify that the
SFC CHASSIS NUMBER
3.
CHASSIS NUMBER
switch to
Set the
switch to
4.
CONFIG SIZE
TXP-T1600-3D configuration, TXP-T4000-3D configuration, or TXP-Mixed-LCC-3D
configuration. For more information, see the TX Matrix Plus Router Hardware Guide.
Close the cover over the
5.
Using a Phillips (+) screwdriver, number 2, tighten the screw for the cover over the
6.
SFC CHASSIS NUMBER
and
CONFIG SIZE
are settings on physical switches located
SFC CHASSIS NUMBER
and
CONFIG SIZE
switches.
switch is set to
00
.
for the TXP-T1600 configuration, or
0
SFC CHASSIS NUMBER
and
and
switches.
CONFIG SIZE
Step 6: Ground the TX Matrix Plus Router
and
CONFIG SIZE
. If needed. set the
00
SFC
for the
3
CONFIG SIZE
switches.
:
23
Advertisement
Table of Contents
