Omron ZW-8000 Series User Manual page 45

2
Insert the wire into the terminal hole.
• When you use a wire attached rod terminal, you can in-
sert just with Push-IN.
• When using single wire, or stranded wire
Insert the wire deeply in to the terminal hole while
pushing the release button on the side of terminal hole
using a screwdriver.
Important
• After the connection has been established, pull the wire gently, to make sure that the connection has been made
securely.
• Being careful not to accidently be injured when pushing the release button with a screwdriver, make sure to tightly
secure to the terminal block.
• Do not use 24V power terminal board which is used inZW-CE series.
3
Reinstall the 24 V input terminal block to the Sensor
Controller.
2 Installation and Connections p.53
ZW-8000/7000/5000
User's Manual
Basic Operations for Displaying Measurement Results
43